Hi -
I recently collected data on an Agilent 6545 QTOF in negative and positive mode. The analysis of the positive mode data ran fine - I was able to get to the main screen after searching and alignment. However, the same data set but in negative mode, I wasn't able to get passed the Analysis parameter setting. I set it up the same exact way (albeit for negative mode).
I have tried versions 4.90 and 4.92, and on different computers and have obtained the same result.
Any advice helps.
Thanks,
Fernando
The problem has been sorted! It turns out the layout of my post-identification .txt for my SPLASH internal standards were not in the correct layout. It just never proceeded forward without a warning.