Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - MetGG

2
XCMS Online / Re: process UHPLC-QTRAP data
Sorry I omitted to mention it: the QTRAP operates at low resolution, like a triple quadrupole. That's why I intend to use the template for HPLC-single quad, but adapt a bit parameters to take into account the fact that UPLC is employed. So I thought maybe an increased step size will perform better.

Could I still use Centwave on low resolution data?

Thanks for you answer
3
XCMS Online / process UHPLC-QTRAP data
Hi,

I wish to acquire UHPLC-QTRAP data in scan mode and use XCMS online to process them. I have selected HPLC-single quad as a starting point, but I need to adapt some parameters since UHPLC is to be used (10min gradient). From the pre-defined parameters, I am tempted to change:

1. Feature detection>FWHM, 3-6 sec
2. Feature detection>Step at 0.1or a bit more?
3. Retention time correction>Initial grouping:bw, 3-6?
4. Alignment>bw, 2-4 sec?

All the other parameters would remain unchanged. Does it look acceptable?

And a last question: can XCMS online deal with both centroid and profile data or one is better than the other? I guess if a step window of 0.1 Da is used, centroid would be better?

Thanks for your help,
Best regards