Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - JL

2
MS-DIAL / What's the difference between adduct under Identification tab and adduct tab?
Hi,

In the lipid database setting, there are two places that we could select adduct. One is under "Identification" tab,  where we choose lipid class and adduct type. Under "Adduct "tab, we could also choose adduct again. What's the difference between the adduct under "Identification" tab and "Adduct" tab?
Thanks!

JL
3
MS-DIAL / MS2 spectra Precursor value in alignment result "Rep. vs. Ref" tab
Hi All,

One question about the MS2 spectra Precursor value in the alignment results "Rep. vs. Ref." tab, see the highlighted part with red rectangle in the picture. This value is  not consistent with the measurement value (>0.1 Da difference). How is this MS2 spectra Precursor value obtained in MS Dial? I am manually curating this lipid, and I think for [M+H]+ the measurement doesn't match with the library since the measurement value 648.4619 is not consistent with library value 648.6289 due to >0.1 Da difference. But then I found this piece of info "MS2 spectra Precursor: 648.62781" on this tab. If the MS2 (DDA) is performed at this value, then the measurement value would match really good with library. I guess my question is how to make a right judgement based on these information.

Could anyone help? Thanks!

JL