Skip to main content ↑ ↓
Topic: MS-DIAL not progressing to the next step after Analysis Parameter Setting (Read 2672 times) previous topic - next topic

MS-DIAL not progressing to the next step after Analysis Parameter Setting

Hi -

I recently collected data on an Agilent 6545 QTOF in negative and positive mode. The analysis of the positive mode data ran fine - I was able to get to the main screen after searching and alignment. However, the same data set but in negative mode, I wasn't able to get passed the Analysis parameter setting. I set it up the same exact way (albeit for negative mode).

I have tried versions 4.90 and 4.92, and on different computers and have obtained the same result.

Any advice helps.

Thanks,
Fernando
 

Re: MS-DIAL not progressing to the next step after Analysis Parameter Setting

Reply #1 –
The problem has been sorted! It turns out the layout of my post-identification .txt for my SPLASH internal standards were not in the correct layout. It just never proceeded forward without a warning.