Skip to main content
Topic: Error occurred in JointAligner (Read 2085 times) previous topic - next topic

Error occurred in JointAligner

I have been using MS-DIAL for years. However, today suddenly MS-DIAL does not show the alignment result. The message in the subject line appears and then, the program crashes.
This is the last version 4.92, my raw data is Agilent, converted in ABF as usual

How can I solve this problem?

 

Re: Error occurred in JointAligner

Reply #1
Hi Roberto,
[A] Very likely that one of the files is corrupt or does not have good data. Or, one of the file is run on different ionization modes.
Just leave out a few in the set and see which is the culprit file!
At least these 2 have affected me in the past, so worth trying.....

Thanks,
Biswa