peak picking March 29, 2021, 12:40:13 AM HelloI can't get the the compounds in the attached picture to peak pick. It's 3 isomers.The peak picking settings were: min. peak height = 5000 amplitude; mass slice width = 0.1 DaI left most other settings at default. Quote Selected
Re: peak picking Reply #1 – March 29, 2021, 11:55:05 PM Hi, not sure the reason, but try to set "1" for minimum data point width of peak detection tab as discussed in the below topic.http://www.metabolomics-forum.com/index.php?topic=1609.0Thanks,Hiroshi Quote Selected
Re: peak picking Reply #2 – March 30, 2021, 09:33:55 AM Hi HiroshiI'm not sure that's helping. But, I haven't been able to try many times because the sample processing keeps hanging (the progress bar just stops mid-way). I'm not sure if anyone else is experiencing that. I'm using the latest version. Quote Selected
Re: peak picking Reply #3 – March 31, 2021, 09:06:04 AM I would say that processing hangs up about 99% of the time. Even with just 1-2 samples. Quote Selected
Re: peak picking Reply #4 – April 04, 2021, 12:10:23 PM Hi,I don't think it's just isomers.Rather large, single peaks are also not getting picked.This is Thermo RAW data without mzML conversion.Also, you can see that, in the manual XIC table, you cannot delete entries in the table. Quote Selected
Re: peak picking Reply #5 – April 13, 2021, 07:45:04 AM Not sure your data detail. Could you please send me one of your data with the PPT slides to explain the detail of your situation. The PPT slides containing ms-dial start up setting and parameter conditions' screenshots are very helpful for me.Thanks,Hiroshi Quote Selected